| Name: | Description: | Used in/Using parameters: | Default expression (mm): |
| FE | Defines the flap extension, which has an impact on the overlapping of the Flaps. Usually, it represents the real overlap partition of the flap. FE has a bound and can not be greater than W/2. If the FE is greater than W/2, all Flaps will theoretically jut out of the box, i.e. the box will not close. |
Used In: FH (Flaps) Using: W (Main) |
20 |
| FH | 0202a, 0202b: Defines the flap height taking into account not only the correction when the folding is at 90 degrees and is parallel to the X axis, but also the width layers correction (Wlc). For example, when you apply a new width, the Flaps, adjoining the 'height' sides, should resize also. |
Used In: FH1 (Flaps) Using: W (Main) C90X (Corrections) Wlc (Layers) FE (Flaps) |
(W+Wlc)/2+FE+C90X |
| 0202: Defines the flap height taking into account flap extension as well as the correction when the folding is at 90 degrees and is parallel to the X axis. |
Used In: FH1 (Flaps) Using: W (Main) C90X (Corrections) FE (Flaps) |
W/2+FE+C90X | |
| CT1 | Correction of the trapezium-shaped slit. | - | 2 |
| DxTB1 | Horizontal size of trapezium-shaped slit bevel. | - | 2 |
| FH1 | Defines the flap height taking into account the correction when the folding is at 90 degrees and is parallel to the X axis as well as layer step crease correction. |
Using: UL (Main) LSC (Layers) FH (Flaps) |
FH+UL*LSC |
| CT2 | Correction of the trapezium-shaped slit. | - | 3 |
| DxTB | Horizontal size of trapezium-shaped slit bevel. | - | 5 |
| DxTB2 | Horizontal size of trapezium-shaped slit bevel. | - | 3 |