| Name: | Description: | Used in/Using parameters: | Default expression (mm): |
| SE | Defines the Slot extension. Another words, it represents the distance between the creases of two adjacent flaps, taking into account that the one should overlap the other. Usually, the overlapping flap has a 'shorter Slot', measured from the outermost, top flange. | - | 2 |
| SW | Defines the real width of the slots. To define larger slots, enter greater value in the expression field. |
Used In: SW2, SW1 (Slot) |
SlotWidth(d()) |
| SW2 | 0712: Defines the width of the Slot adjacent to the glue flap. Defines the real width of the Slot adjacent to the outermost part that has to meet the glue flap. Usually SW2 is set to 0. |
Used In: DxCh (Slot) Using: SW (Slot) |
SW/2 |
| 0712a: Defines the width of the Slot adjacent to the glue flap. Defines the real width of the Slot adjacent to the outermost part that has to meet the glue flap. Usually SW2 is set to 0. |
Used In: DxCh (Slot) Using: EdgeType (Slot) |
switch(EdgeType, Flat, 0, Chamfer, d(), LineExt, d()) | |
| EdgeType | - |
Used In: SW2, SW1 (Slot) |
Flat |
| ExtL | - | - | 3 |
| SW1 | 0712a: Defines the real width of the Slot adjacent to the outermost part that has to meet the glue flap. By default, SW1 is SW/2, because here you have a half-Slot. Of course, you may enter a different value to fully meet your 'resizing' needs. . |
Used In: DxCh (Slot) Using: SW (Slot) |
SW/2 |
| 0712: Defines the real width of the Slot adjacent to the outermost part that has to meet the glue flap. By default, SW1 is switch(EdgeType, Flat, 0, Chamfer, d(), LineExt, d()), because here you have a half-Slot. Of course, you may enter a different value to fully meet your 'resizing' needs. . |
Used In: DxCh (Slot) Using: EdgeType (Slot) |
switch(EdgeType, Flat, 0, Chamfer, d(), LineExt, d()) | |
| DxCh | 0712: - |
Used In: ChL (Slot) Using: SW1 (Slot) |
SW1 |
| 0712a: - |
Used In: ChL (Slot) Using: SW2 (Slot) |
SW2 | |
| ChL | - |
Using: DxCh (Slot) |
3 |