| Parameter: | Group: | Used in/Using parameters (direct dependence): | Where would the design resize when I change the parameter expression: |
| A | Main |
Used In: B (Main) CL (Cut) DxTB1, x (Trapezium) |
Length of the box |
| B | Main |
Used In: SA1 (Sealing Top) SA (Sealing End) Using: A (Main) |
Width of the box |
| H | Main | - | Height |
| GLC | Main | - | Correction because of the glue flap |
| UL | Main |
Used In: alpha (Trapezium) |
Defines if layers should be used |
| LSC | Layers |
Used In: alpha (Trapezium) |
Layer step crease |
| PH2 | Sealing Top |
Used In: SA1 (Sealing Top) VCO (Cut) |
Panel height |
| SA1 | Sealing Top |
Using: B (Main) PH2 (Sealing Top) |
- |
| PH | Sealing End |
Used In: SA (Sealing End) |
Panel Height |
| PH1 | Sealing End | - | Panel height |
| SA | Sealing End |
Using: B (Main) PH (Sealing End) |
- |
| CL | Cut |
Used In: DxTB1, x, CR, y (Trapezium) Using: A (Main) |
Cut length |
| VCO | Cut |
Used In: TPH (Trapezium) Using: PH2 (Sealing Top) |
Vertical cut offset |
| TPH | Trapezium |
Used In: alpha (Trapezium) Using: VCO (Cut) |
Trapezium height |
| DxTB1 | Trapezium |
Used In: alpha, x (Trapezium) Using: A (Main) CL (Cut) |
Horizontal size of trapezium bevel |
| alpha | Trapezium |
Used In: beta (Trapezium) Using: UL (Main) LSC (Layers) TPH, DxTB1 (Trapezium) |
Triangular flap angle |
| beta | Trapezium |
Used In: CR, y (Trapezium) Using: alpha (Trapezium) |
- |
| x | Trapezium |
Used In: CR, y (Trapezium) Using: A (Main) CL (Cut) DxTB1 (Trapezium) |
- |
| CR | Trapezium |
Used In: CH (Trapezium) Using: CL (Cut) beta, x (Trapezium) |
Curcle radius |
| y | Trapezium |
Used In: CH (Trapezium) Using: CL (Cut) beta, x (Trapezium) |
- |
| CH | Trapezium |
Using: CR, y (Trapezium) |
Cut height |
| GL | Glue Flap | - | Glue flap width |