| Parameter: | Group: | Used in/Using parameters (direct dependence): | Where would the design resize when I change the parameter expression: |
| DIC | Main |
Used In: L1 (Main) PH, PH1, DxPT, DyPT, DxPB (Hexagonal Panel) |
- |
| L1 | Main |
Used In: HL, HHO, HO1, HO2 (Hole) Using: DIC (Main) |
Length |
| H | Main |
Used In: HW2, VHO (Hole) |
Height |
| UL | Main |
Used In: TPH (Trapezium) |
Defines if layers should be used |
| LSC | Layers |
Used In: TPH (Trapezium) |
Layer step crease |
| GLC | Main | - | Correction because of the glue flap |
| CrO | Main |
Used In: VHO (Hole) |
Crease offset |
| TEO | Hexagonal Panel |
Used In: PH1 (Hexagonal Panel) |
Tuck End Offset |
| PH | Hexagonal Panel |
Using: DIC (Main) |
Panel Height |
| PH1 | Hexagonal Panel |
Using: DIC (Main) TEO (Hexagonal Panel) |
Panel height |
| DxPT | Hexagonal Panel |
Used In: BAng1 (Trapezium) Using: DIC (Main) |
Horizontal size of the panel taper |
| DyPT | Hexagonal Panel |
Used In: BAng1, TPH (Trapezium) Using: DIC (Main) |
Vertical size of the panel taper |
| DxPB | Hexagonal Panel |
Using: DIC (Main) |
Horizontal size of the panel bevel |
| BAng1 | Trapezium |
Using: DxPT, DyPT (Hexagonal Panel) |
Trapezium bevel angle |
| BAng2 | Trapezium | - | Trapezium bevel angle |
| TPH | Trapezium |
Using: UL (Main) LSC (Layers) DyPT (Hexagonal Panel) |
Trapezium height |
| TCR | Tumb Cut | - | Tumb Cut radius |
| HW2 | Hole |
Used In: HW1, VHO (Hole) Using: H (Main) |
- |
| HW1 | Hole |
Used In: VHO, HFR (Hole) Using: HW2 (Hole) |
Hole width |
| HL | Hole |
Used In: HHO, HO2 (Hole) Using: L1 (Main) |
Hole Length |
| HHO | Hole |
Used In: HO1 (Hole) Using: L1 (Main) HL (Hole) |
Horizontal hole offset |
| VHO | Hole |
Using: H, CrO (Main) HW2, HW1 (Hole) |
Vertical hole offset |
| HFR | Hole |
Using: HW1 (Hole) |
Hole fillet radius |
| HO1 | Hole |
Used In: HO2 (Hole) Using: L1 (Main) HHO (Hole) |
Hole offset |
| HO2 | Hole |
Using: L1 (Main) HL, HO1 (Hole) |
Hole offset |
| GL | Glue Flap | - | Glue flap width |
| GLA | Glue Flap | - | Webbed flap angle |